Specifications:
Thread size: 1/4-20 (both sides)
Overall length: 4 1/2"
Length to center flange: 2" & 2.4"
Quantity: 1
Fits:
Holley…see more
Air Horn Vent Tube
3/8" OD x 1" L
Quantity: 1 tube…see more
Chrome steel 3/16" ball is used in the accelerator pump system as a one-way check valve. Replaces original check ball…see more
Quantity: 3 screws.
Size: 8-32 x 5/16" (length does not include screw head)
Fits:
Carter BB carburetors (wire clamp screw)
Carter…see more
Use to repair stripped throttle shaft threads.
Use with 6-32 threading tap. (Item #4926)
Quantity: 20 screws.
Repairs:
Rochester Quadrajet carburetors…see more
Quantity: 20 screws.
Size: 3-48 x 1/4" (length does not include screw head)
Fits:
Rochester Quadrajet carburetors (primary & secondary throttles)
Rochester Quadrajet carburetors…see more
Mixture Control Solenoid Plug seals up hole in airhorn directly above MCS adjustment screw.
Overall Length: .410"
Major Diameter: .200"
Minor…see more
Retainer Dimensions-
E-Clip size: 1/8"
Thickness: .017"
O.D.: .230"
Throat Opening: .090"
Quantity: 10 retainers
Note:
E-clip sizes refer to diameter…see more
Retainer pin is used on many carbs to hold various rods and linkages. Always handy to have several on hand,…see more
Retainer Dimensions-
Wire thickness: .032"
Width: .155"
Length: .435"
Quantity: 10
Fits:
Carter BBS carburetors
Carter RBS carburetors
Ford/Motorcraft 1100, 1101…see more
Rod-Clip Retainers are used on many carbs to hold various rods and linkages. Retainer is installed over linkage rod and…see more
Rod-Clip Retainers are used on many carbs to hold various rods and linkages. Retainer is installed over linkage rod and…see more
Special clip used to retain throttle linkage on several Rochester models. Direct replacement for original retainer. Package of 1. Rochester OEM# 10035905,…see more
Fits:
Carter BB carburetors (wire clamp screw)
Carter BBS carburetors (compinsator screw, choke pull-off)
Carter RBS carburetors
Carter YF carburetors
Carter YFA carburetors…see more
Self tapping thermostat cover screws replace originals. Philips head. Used to replace choke housings with riveted thermostats. Qty: 3 screws (10-32…see more
Throttle lever ball stud is used to attach throttle cable to carburetor arm.
Thread size: 1/4-20
Thread length: .410"
Stud diameter: .187"
Stud length:…see more
Throttle lever stud is used to attach throttle cable to carburetor arm.
Thread size: 5/16-18
Thread length: .410"
Stud diameter: .225"…see more