JavaScript seems to be disabled in your browser.

You must have JavaScript enabled in your browser to utilize the functionality of this website. Click here for instructions on enabling javascript in your browser.

Needle and Seat Repair Assembly, Repairs stripped needle and seat threads

Very limited quantities.
Use this needle and seat to repair stripped threads. 

Fits: Quadrajet and Dualjet carburetors

Installation Instructions:
Drill needle & Seat bore to .4375" using a sharp 7/16" drill.
Slightly chamfer leading edge of bore with .500" drill to ease installation.
Thoroughly clean casting and all passages.
Lightly lubricate o-rings with wd-40.
The lower section of the repair fitting is threaded.  This allows the O-rings to be expanded for a great seal. Slightly loosen the lower portion of the fitting.
By hand, press assembly in the newly drilled bore. You may need to gently tap it with a 3/8" deep socket to fully seat assembly.
Gently turn by hand the hex portion of fitting clockwise to tighten (snug) assembly, locking it into place.  Just use a deep 3/8" socket and turn with your fingers, do NOT use rachet to tighten!
Install float and reset float height.

Quantity:
Twitter
Stumbleupon
Reddit
Pintrest
Newsvine
Linkedin
Google+
Google
Facebook
Digg
Related Products
Related Categories