Complete DIY carburetor bushing installation kit allows you to install bushings on all carburetors with 3/8" throttle shafts.
Works on Rochester Quadrajet secondary throttle shafts.
Kit contains everything you need to correctly do the job yourself. The key to this kit is the specially machined piloted drill that aligns itself with the existing throttle shaft bore. Complete and detailed instructions are included.
Enough supplies included to install bushings on 3 carburetors. Bulk 10-pack bushings are available separately (#4313).
Carburtors with worn throttle shaft bores allow excessive unfiltered air to enter the engine and since the carburetor "doesn't see" this air, it can't compensate for it with the proper amount of fuel. A worn shaft can cause an erratic idle and throttle binding issues.
3/8" Bushing Kit includes:
1 Specially machined piloted drill
1 Drill stop collar
6 Oil impregnated bronze carburetor bushings
Aluminum bushing driver
12 Throttle shaft screws (for the Rochester Quadrajet carburetor)
Complete instructions included
Replacement parts available seperately:
#4313 - 10 pack of throttle shaft bushings
#4212 - 20 pack of Quadrajet throttle shaft screws
Rochester Q-Jet carburetors (Secondary throttle shaft)
Also works on the following carburetors (w/exception of throttle screws supplied)
Carter Thermo-Quad carburetors
Holley four barrel carburetors
Ford Autolite carburetors
All carburetors with 3/8" throttle shafts.
Electric hand drill
Small hand file
A Note About the Special Machined Drill Bit Included In This Kit:
The drill has been ground down to fit into the throttle shaft outer and inner bore. The actual cutting edge on the drill is approx. 1/2" from the bottom of the drill flutes.